我昨天也買了兩罐,打算下次換機油前,再來清洗;目前里程數為30200公里左右。
至於使用方式,在GO UP台灣代理商的網站裡就有寫到:
在罐子上也有寫
http://www.goupracing.com/
產品網頁
http://www.motoforge.com.tw/goup/_private/e-flush.htm
This product was created specifically for 4-cycle gas engine or any diesel engine. Please note that the following steps must be performed after engine warm-up.
此產品用在四行程汽油引擎和柴油引擎,請在暖機之後,按照步驟操作。
1.Turn off the engine.
關閉引擎。
2.Drain the old oil completely.
把舊機油洩下。
3.Fill the engine with X liter of engine flush where X is your engine capacity. For example, add 1-litter of engine flush for a 1-litter engine. No need to change oil filter at this time.
看引擎機油量多少,就加入多少的清洗油,不需要更換機油濾清器(濾心) 。
4.Make sure all oil plugs are tighten
確定螺絲、機油尺都鎖緊了。
5.Start the engine.
發動引擎。
6.Keep the engine in idle speed for at least 15 minutes. Do not move the vehicle or increase the engine speed.
怠速至少15分鐘,勿移動車輛或提高轉速。
7.Turn off the engine.
關閉引擎。
8.Drain the engine flush completely.
把清洗油洩下。
9.Fill the engine with engine oil and change the oil filter.
將機油加到交換量和更換機油濾清器(濾心) 。
翻得不好,請多見諒= =y
[ 本文章最後由 lls613 於 2010-6-9 14:26 編輯 ] |
